I would like to explore the possibility of creating an extension rod for the rear table.
I find that when the table is in place it makes it tight for two of us to work in the galley and reduces access to the sink.
My thought is to create an additional support that would attach on to the existing rear table supports but extend across the back of the Teardrop to allow the table to be attached further out.
Hard to put into works and award to make a mock up without the brackets as you would need another set of male/female brackets to attached to this extension.
Final design could incorporate a sliding system integrated into the table so you can adjust at will to site conditions.
We find with the Northern Breeze up and the side tent on one side we have spare space on this side that is not utilised.
Not being an engineer I'm not sure of the stresses or moments this extension would cause.
I find that when the table is in place it makes it tight for two of us to work in the galley and reduces access to the sink.
My thought is to create an additional support that would attach on to the existing rear table supports but extend across the back of the Teardrop to allow the table to be attached further out.
Hard to put into works and award to make a mock up without the brackets as you would need another set of male/female brackets to attached to this extension.
Final design could incorporate a sliding system integrated into the table so you can adjust at will to site conditions.
We find with the Northern Breeze up and the side tent on one side we have spare space on this side that is not utilised.
Not being an engineer I'm not sure of the stresses or moments this extension would cause.