CI side molding
- Thread starter Chaos
- Start date
)
Mark & Casandra
Junior Ranger
Looks great! I really like it!
How does it go on? Glue it or peel & stick type backing? Care to share where you got it? I'm trying to picture this on a 560....not sure it would look as cool or be as aerodynamic.
Casandra
How does it go on? Glue it or peel & stick type backing? Care to share where you got it? I'm trying to picture this on a 560....not sure it would look as cool or be as aerodynamic.
Casandra
Chaos
Newbie
The molding is attached with adhesive tape (peel & stick) pre-mounted on the molding
I used 1-3/8” wide molding manufactured by “Trim-Gard”
There was enough linear feet in two packages to cover the distance, but I needed to order 3 pack to get enough pieces with 'bullet tips' for the door-facing ends. (the rear-facing ends were cut to follow the contour of the rear galley.
I mapped it out with masking tape prior to the molding application to get the spacing right.
I used 1-3/8” wide molding manufactured by “Trim-Gard”
There was enough linear feet in two packages to cover the distance, but I needed to order 3 pack to get enough pieces with 'bullet tips' for the door-facing ends. (the rear-facing ends were cut to follow the contour of the rear galley.
I mapped it out with masking tape prior to the molding application to get the spacing right.
Very cool look. Good job, well done!
It looks great.
